With the NXT, it is not necessary to generate recipes in order to transmit the job to the machine. Reports are only generated during the recipe generation process. Therefore, in order to view reports, it is necessary to generate recipes. If data in the job has been changed that needs to be reflected in a […]
Category Archives: SMT Machines MRO
24
Sep
Sep
The control board (reader control board assy) controls the ID reader boards. Up to 3 reader boards can be used with one control board. The control board also sends information obtained with the reader boards to the controller in the main machine (surface mounter). Hooking up the connectors The wire harness from the ID reader […]
23
Sep
Sep
When using CLi feeder exchange carriages, you must set their own ID as explained below. A list of ID settings is also shown. 1. Disconnect the feeder exchange carriage from the surface mounter. 2. Remove the front cover. Using a Phillips (+) screwdriver, remove the four screws securing the front cover (with a clear, plastic […]
20
Sep
Sep
Action: Check that air pressure drops down below the standard values. Error Code: $2001 | Symptom and Cause: Can’t move up the back up table (BUT). Backup table(BUT) fails to move up. Error Code: $2002 | Symptom and Cause: Can’t move down the back up table (BUT). Backup table(BUT) fails to move down. Error Code: […]
19
Sep
Sep
Proper nozzle setup is essential to success The first troubleshooting step is ensuring the proper nozzle / setup is being used. This is one of the easiest steps and results in the fastest improvements. Pick nozzles and process parameters for SMDs have been developed for many years. The softer silicone dome of a SMT LED […]
18
Sep
Sep
Signal monitor display LED display Display: OPERATION Display: Green Function: Power display Lighting conditions: Power supply is inputted. Display: ALARM Display: Red Function: Alarm display Lighting conditions: Protective function is activated. Alarm contents Number of flickering: 1 Function: Protection from overheat Lighting conditions: The temperature of the radiator within the driver reaches approx. 85-degrees centigrade […]
17
Sep
Sep
LED SMT Placement • LEDs sometimes require specific process parameters for the best pick and place performance. • This is due to the dome material and unbalanced weight distribution of some types of LED component. • Vendor support and knowledge is typically needed to handle the LEDs and meet high-speed, high yield SMT manufacturing process […]
12
Sep
Sep
1. Action: Drive a motor to all directions with Jog Key in order to check the motor for proper operation. Error code: $1A10 | Symptom and Cause: Timeout while homing (X axis error) Fails to find out position of Home of motor within limited time. Error code: $1A20 | Symptom and Cause: Timeout while homing […]
11
Sep
Sep
Module: X-Y Axis Part 1. Action: Drive the motor associated to opposite direction with Jog Key so as to go out of limit position. Error Code: $13D3 Symptom and Cause: Driving part of Z-axis motor is reached to software limit of negative(-) direction select 2. Action: When using System ANC, be sure to teach again […]
10
Sep
Sep
Module: X-Y Axis Part, Part No.1 1. Action: Check Nozzle Data with command of in MMI and then input the correct data. Error Code: $0100 Symptom and Cause: Invalid nozzle length Invalid nozzle length value among Nozzle data.(0 value is inputted.) 2. Action: Drive the motor associated to opposite direction with Jog Key so as […]