Alarm Display: A.021 Alarm Name: Parameter Format Error Occurred Situation at Alarm Occurrence: when the power was turned ON again after writing the parameter with the parameter copy function of the digital operator (JUSP-OP05A). Cause: The model number of the SERVOPACK in the software being used for the SERVOPACK is old and not compatible with […]
Category Archives: SMT Machines MRO
The NXT represents a new concept in the SMT field and is very different from previous Fuji machines. Due to these differences, there some different procedures when programming for the NXT in Fuji Flexa. A brief listing of the major differences is included below. The line configuration for NXT machines. The machine configuration for the […]
Error Code: 103 Error Text: Invalid changeover method Invalid changeover method. Description: This is a software error. The function is not yet implemented. Solution: Report error to your service representative. Error Code: 104 Error Text: Invalid order start count Description: The starting count must be al least1. Solution: Change the starting count. Error Code: 105 […]
Illustrates the placement of the jumper headers, connectors, configuration switches, and various other components on the MVME162P4. Manually configurable jumper headers and configuration switches on the MVME162P4 are listed in the following table. #1 Function: VME System Controller (J1) | Factory Default: 2-3 #2 Function: IP Bus Clock (J14) | Factory Default: 1-2 #3 Function: […]
The information presented in this page applies to the following MVME162P4 models: #1 Model Number: MVME162P-244L | Characteristics: 25MHz 68LC040, 16MB SDRAM, 2 SIO, 4 DMA IP #2 Model Number: MVME162P-244LE | Characteristics: 25MHz 68LC040, 16MB SDRAM, 2 SIO, 4 DMA IP, Ethernet #3 Model Number: MVME162P-244LSE | Characteristics: 25MHz 68LC040, 16MB SDRAM, 2 SIO, […]
Alarm Contents: Other failure alarm Operating Condition: After control power is turned on After main power is turned on While the motor is running Causes: Malfunctioning of the control circuit owing to the noise. Alarm raised by the self-diagnosis function of the amp. Measures: Turn off the power then turn the power on again and […]
Alarm Contents: Motor encoder CS phase check alarm. Operating Condition: After control power is turned on. Causes: CS phase power output failure In the Servo-motor encoder. Motor encoder cable connection error or failure. Measures: Servo-motor change. Motor encoder cable check and change.
Alarm Contents: Motor encoder Z phase check alarm Operating Condition: After control power is turned on Causes: Z phase power output failure In the Servo-motor encoder. Motor encoder cable connection error or failure. Measures: Servo-motor change. Motor encoder cable check and change.
Alarm Contents: Servo-Amp. Parameter check failure alarm. Operating Condition: After control power is turned on. Causes: Data loss in the Servo-Amp. memory Servo-Amp. damaged Measures: Re-setting the parameter depending on the Servo-Amp. Servo-Amp change.
Alarm Contents: Servo-Amp. parameter setting failure alarm. Operating Condition: After control power is turned on. Causes: Data loss in the Servo-Amp. memory Servo-Amp. damaged Measures: Re-setting the parameter depending on the Servo-Amp. Servo-Amp change.