SMT Industry Blog & Knowledge Base

Deep dives into Surface Mount Technology. Expert advice on pick-and-place nozzle maintenance, feeder calibration, stencil printing efficiency, and yield optimization.

June 17, 2018 • By admin

Panasonic Nozzle Parts List For NPM Series Part 1 – For 16 Nozzle Head And 12 Nozzle Head

Item # Part Number Part Name Remarks 1 N610038265AB NOZZLE No.203ZS 2 N610119472AA NOZZLE No.203ZSN Mark Bar Code 3 N610043702AB NOZZLE No.140S 4 N610119473AA NOZZLE...

Read Article →

June 17, 2018 • By admin

Samsung CP-45F(V)/FS Appendix C Shuttle Tray Feeder

After the Shuttle Tray Feeder has been installed, register it from the “Tray Feeder Setting” dialog box (Sys. SetupÆTray) in Figure C-1 as follows. 1...

Read Article →

June 15, 2018 • By admin

Nozzle Specifications of Universal UIC Surface Mount Product Line 4797 A/S/L HSP High Speed Chipshooter

Nozzle Type Number Applicable Component Typical Components Thickness Nozzle end diameter (mm) 11 0603 (1608) Chips 0.45 mm to 0.8 mm (0.018 to 0.031) 0.9...

Read Article →

June 14, 2018 • By admin

Summary of FUJI CP643E Servo Adjustment Procedure

The mechanical check software (servo adjustment software) is used to perform CP643E’s servo adjustment. The servo adjustment procedure using mechanical check software is described below....

Read Article →

June 13, 2018 • By admin

Control Box on Yamaha YV100II KM8-9910 Full Vision Surface Mounter

01. Part name: MOTHER, KM5, Part number: KM5-M4510-10X. 02. Part name: D. POWER ASSY., Part number: KM5-M5880-01X. 03. Part name: SYSTEM UNIT ASSY., Part number:...

Read Article →

June 12, 2018 • By admin

System Mechanics of UIC Universal VCD Single Head 8 Axial Lead Inserter (6687C) and Jumper Wire Single Head 8 (6683C)

X-Y Positioning System The X-Y positioning system locates the printed circuit board under the insertion tooling and is equipped with a rotary indexing table that...

Read Article →

June 11, 2018 • By admin

Incorrect values for max. and min. travel paths of Z axis in Siplace C&P20

The memory of the intermediate distributor can contain incorrect values for the maximum and minimum travel paths of the Z axis Machie Model: Siemens ASM...

Read Article →

June 8, 2018 • By admin

Error Code: 102 – Invalid serial number range on Assembleon ACM

Error Text: Invalid serial number range Description: The serial numbers must be correctly formatted and the ranges are not allowed to overlap. Solution: Check out...

Read Article →

June 7, 2018 • By admin

Error code: 0100 on Samsung CP40 Pick and Place Machine.

Module: X-Y Axis Part Error Code: $0100 Cause: Invalid nozzle length Invalid nozzle length value among Nozzle data.(0 value is inputted.) Solution: Check Nozzle Data...

Read Article →

← Prev 1 … 107 108 109 110 111 … 115 Next →

SMT Industry Blog & Knowledge Base

SMTBOX Assistant