Illustrates the placement of the jumper headers, connectors, configuration switches, and various other components on the MVME162P4. Manually configurable jumper headers and configuration switches on the MVME162P4 are listed in the following table.
#1 Function: VME System Controller (J1) | Factory Default: 2-3
#2 Function: IP Bus Clock (J14) | Factory Default: 1-2
#3 Function: SIM Selection for Serial Port B (J15) | Factory Default: SIMM06
#4 Function: Serial Port 1/Console Clock (J16) | Factory Default: No Jumpers
#5 Function: Serial Port 2 Clock (J17) | Factory Default: No Jumpers
#6 Function: IP Bus Strobe (J19) | Factory Default: No Jumper
#7 Function: SRAM Backup Power Source (J22) | Factory Default: 1-3, 2-4
#8 Function: EPROM Size (J23) | Factory Default: 2-3
#9 Function: Flash Write Protection (J24) | Factory Default: Jumper On
#10 Function: MC2 DRAM Size (S3) | Factory Default: Off-Off-Off
#11 Function: General-Purpose Readable Switch (S4 Pin 5) | Factory Default: On
#12 Function: IP DMA Snoop Control (S5 Pins 1/2) | Factory Default: On-On
#13 Function: IP Reset Mode (S5 Pin 3) | Factory Default: On
#14 Function: Flash Write Enable Mode (S5 Pin 4) | Factory Default: On
#15 Function: MCECC DRAM Size (S6) | Factory Default: On-Off-On
Note: J3 is a PLD programming header for lab or factory use. It has no user function.