SMTBOX – THT / SMT Machines Feeders, Nozzles and Spare Parts Supplier

1.3. Reference For Pickup Height Setup of Samsung Hanwha SME SMT Feeder

The reference plane for Z-axis height of the tape feeder is beneath (above the main frame) the tape at the pickup position.

Actual pickup height of each part may vary depending on part height and transfer tape thickness as shown in the following figure. In particular, embossed tape must be set according to the actual part height against the pocket depth. It may become a negative (-) value as shown in the following figure.

1: Upper cover tape
2: Tape guide
3: Frame
4: Part

The Z value of the pickup point is applied in various ways according to the feeder type. In addition, the Z value of the pickup point also varies according to the type of the part supply tape. The embossed tape must be set according to the pocket depth and part height.

Sometimes, the pickup Z value is indicated as a negative (-) value.

Exit mobile version